Full Matrix System training - course outline

This course usually takes two days.

Part One: The Basics

• 1.1: Introduction
• 1.2: Hardware Features
• 1.3: 2nd Generation Clamp
• 1.4: 3D Matrix
• (a) Mind the Gap
• (b) Kinematics
• 1.5: Standard Sheet Configurations
• (a) Choosing the correct size
• 1.6: Flexible Matrix
• (a) Applications
• (b) Stiffness / Flexibility

Part Two: Fitting Methods

• 2.1: Direct Shell Fitting
• (a) Taking Measurements for the Pre-measurement Method
• (b) Sheet Layout for the Pre-measurement Method
• (c) Matrix Fitting
• - With Fitting Frame
• - With Tilt in Space Wheelchair
• 2.2: Indirect Shell Fitting
• (a) Bean Bag and Casting Techniques
• (b) Sheet Size Selection and Draping
• 2.3: Direct Back Fitting
• (a) Introduction to the Technique
• (b) Choosing Back Sizes and Mounting Components
• - Choosing Back Sizes
• - Mounting Hardware
• (c) Shaping Management
• (d) Back Covers
• (e) Component Chart

Part Three: Shell Forming and Finishing

• 3.1: Use of Standard 2-ball Array
• 3.2: Custom Use of the 'Spiders'
• 3.3: General Do's and Don'ts

Part Four: Reinforcement

• 4.1: Basics
• (a) Standard Locations
• (b) Back Recommendations
• 4.2: Carbon Fibre Cladding
• (a) Heat and Drape
• 4.3: Component Chart

Part Five: Wheelchair Mounting

• 5.1: Shell Mounting
• (a) Seat Feet, Ball Standoffs and Back Feet
• - Adjustable Channel Base
• (b) Other Hardware
• - Pommel + Spinal Channel
• 5.2: Component Chart